An alias I made for Cisco nexus switches to show the current hierarchical configuration
(Works like cur in Alteon)
Exampe
SW1-1(config)# int e3/9 SW1-1(config-if)# cur interface Ethernet3/9 switchport switchport mode trunk switchport trunk native vlan 70 switchport trunk allowed vlan 70,100 no shutdown SW1-1(config-if)# vdc SW1-4 SW1-1(config-vdc)# cur vdc SW1-4 id 4 limit-resource module-type m1 f1 m1xl allocate interface Ethernet1/25-32 allocate interface Ethernet2/25-32 allocate interface Ethernet3/31-48 boot-order 1 limit-resource vlan minimum 16 maximum 4094 limit-resource monitor-session minimum 0 maximum 2 limit-resource monitor-session-erspan-dst minimum 0 maximum 23 limit-resource vrf minimum 2 maximum 4096 limit-resource port-channel minimum 0 maximum 768 limit-resource u4route-mem minimum 8 maximum 8 limit-resource u6route-mem minimum 4 maximum 4 limit-resource m4route-mem minimum 8 maximum 8 limit-resource m6route-mem minimum 5 maximum 5 SW1-1(config-if)#
The alias
cli alias name cur where detail | sed -n 2p | sed "s/^ *//" | sed "s/^/show run | sec '^/" | sed "s/$/$'/" | vsh
The post 
Show current hierarchical configuration for nexus switches appeared first on SharonTools.